Ford Check Engine Light

What could cause the check engine light to come on in a Ford?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Again, the check engine light could again be a warning of an essential problem that could cause serious damage to your engine and come with a hefty and pricey repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady and continuous glow generally means something less serious but a flashing check engine light signifies that your vehicle’s engine is in meaningful trouble and useful service is required expeditiously. If your check engine light is flashing in your Ford, we tremendously endorse not to drive the car and schedule Ford service today. Below is a list of the most common reasons your check engine light can come on:

• The battery is low or dead. The battery in your Ford is each essential. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't genuinely require maintenance. The price of a new one depends on the type of Ford you drive, but check our current service coupons and specials.
• Your Ford has a vacuum leak. Each Ford has a vacuum system that performs a wide variety of functions. The vacuum system again helps lower adverse emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, exceptionally if they’re exposed to intense heat or extreme cold.
• Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ford is what determines how much fuel is necessary to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to certain changes, like altitude. If your Ford is having trouble starting, idling rough or has a sudden fast change in the position of the throttle pedal, this could be a vital sign of a defective mass airflow sensor.
• Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns more immediately and your car will be less efficient when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A defective sensor can not only affect your miles per gallon, but it can cause meaningful damage to your catalytic converter and your Ford 's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the exactly correct mix of air and fuel that enters the cylinders in your engine. A defective O2 sensor can again cause a car to fail an emissions test.
• New Spark Plugs or Plug Wires are necessary for your Ford. The spark plugs are the part of your engine that ignites the air/fuel mix in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run smooth. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience a noticeable poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, leading to more costly repairs.
• Your catalytic converter is bad or going bad. The catalytic converter is a part of your Ford ’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A broken catalytic converter is normally caused by consistently neglected maintenance, which is why Larry H. Miller Super Ford Salt Lake City offers a complimentary multi-point inspection with each Ford service. If you have an issue with your catalytic converter and don't get it repaired, your Ford will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause other perilous problems from overheating.
• Issues with any aftermarket items. An aftermarket alarm, exhaust or other item can wreak extreme havoc on your Ford if it’s not installed perfectly. These aftermarket components and accessories can drain the battery, trigger the check engine light, or even prevent the car from starting. If these issues sound familiar, bring your to Ford and have our team of skilled certified mechanics guarantee that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, exceptionally aftermarket parts and accessories, or utilizing OEM components first place might cost a little bit more but could help you save considerably from having to get poor work and damage caused by poor installation work corrected.
• One of the most common and frequent cause is that your Ford gas cap is loose, broken or missing. The gas cap for your Ford serves numerous purposes. It prevents hazardous gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a defective fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump and be more expensive. Luckily, to replace a gas cap isn't costly. If your check engine light turns on rapidly after you put gas in your Ford, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.

Ford Check Engine Light Codes

The check engine light turning on can be quite intimidating, exceptionally to see that little light on your vehicle’s dashboard suddenly illuminate, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, still known as the OBD (on-board computer diagnostic system) in your. There are hundreds of different codes that your check engine light can accurately represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you helpful knowledge about your vehicle and will still allow that vital Check Engine Light to do what it is really supposed to do: be your guide. Sadly, obvious and useful vehicle symptoms do not regularly accompany an illuminated Check Engine Light. Since there are hundreds of imaginable OBD codes, there are still hundreds of imaginable reasons for the light, including:

• Old Battery
• Ignition system faults
• Transmission issues
• O2 Sensor
• Loose Gas Cap or Missing Gas Cap
• Fuel and air metering systems problems
• Emissions controls issues
• Bad Spark Plugs
• Computer output circuit issues

This is why it is essential for someone who does not have a lot of prevailing automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out instantly by a proficient certified Ford mechanic. If the engine light comes on due to a serious concern, you risk damaging your car further by not repairing the issue right away. Call Larry H. Miller Super Ford Salt Lake City at 3858812581 today or schedule your check engine light service online today!

Will the check engine light reset itself?

The check engine light on your Ford will ordinarily shut itself off if the issue or code that caused it to turn on is fixed. For instance, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will swiftly turn itself off. Also, if your catalytic converter is working accurately, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Ford light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Larry H. Miller Super Ford Salt Lake City so the light and code can be double-checked and reset.

Ford Check Engine Light

If the check engine light in your Ford starts flashing, that means that the problem needs attention immediately and your Ford should be brought in quickly. A flashing light reveals that the problem is immensely serious and if not taken care of immediately may result in major and significant damage to the car. This blinking light ordinarily indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can rapidly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive and huge repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A broken, old or dirty spark plug can cause the engine to misfire. If the problem is totally ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a exceptionally expensive repair. If your check engine light is constantly flashing, please contact our team of automotive experts at Larry H. Miller Super Ford Salt Lake City immediately by calling 3858812581.

How many miles can you drive with the check engine light?

Since each check engine code has its own level of severity, it is ordinarily difficult to predict how many miles you can be secure in driving with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a bad sensor to plug wires needing to be replaced. If you check engine light is flashing, we propose that you pull over and contact Larry H. Miller Super Ford Salt Lake City to help determine if your vehicle is secure to drive in or if we propose a tow truck.

Check Engine Light Service Ford

What do you do when you’re driving along in your Ford and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ford owners, your heart sinks extremely because you may have precisely idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep, tranquil breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your Ford checked rapidly. Ignoring that warning could end up causing major, major damage to expensive engine components.

When your Ford 's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is generally labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that can immediately identify the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Ford auto repair mechanics at Larry H. Miller Super Ford Salt Lake City. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to determine the definitely correct issue and repair it.

Ford Check Engine Light Flashing

Although there are countless potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several common causes including something as simple as a loose gas cap. Other mainly common reasons for a Check Engine Light are damaged oxygen sensor, a malfunction with the fuel injection system, damaged emissions control part, dirty mass airflow sensor, damaged head gasket, or faulty spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ford Certified Mechanics and the certified service protocol to isolate the root problem and entirely repair it as required to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ford issue was completely fixed.

Every Ford was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the car on its essential systems. The fast sensors are continually detecting conditions while sending essential data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, unfortunately that is the limitation of the Check Engine Light – it won’t tell you what precisely is wrong nor what to do about it. That’s where we come in; Larry H. Miller Super Ford Salt Lake City provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Tremendously Qualified Service professional.

What Does the Check Engine Light Mean?

One of the most generally misunderstood lights or indicators in your Ford is the check engine light. The check engine light is part of the important onboard diagnostics system, and displays in a variety of different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your Ford. Some of these essential duties include controlling engine speed, shifting automatic transmissions ignition timing, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of different things. It can be as simple as your gas cap being loose or as unpredictable as engine knocking. If your check engine light is on in your Ford, contact Larry H. Miller Super Ford Salt Lake City . Our Ford service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Larry H. Miller Super Ford Salt Lake City today!

Is it safe to drive your Ford with the check engine light on?

This question is not very simple because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be secure to drive. This is generally indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more serious problem. If the check engine light is flashing, this means that there is a serious issue and it is suggested to service your Ford expeditiously. Call the experts at Larry H. Miller Super Ford Salt Lake City by dialing 3858812581 so you can describe the issues. Or reduce your speed and bring your Ford to our certified mechanics as shortly as possible.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is generally between $88 and $111. The good news, Larry H. Miller Super Ford Salt Lake City offers entirely complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more serious failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it good to get the proper code reading and diagnosis.